1-866-4 JJSTECH(1-866-455-7832)

Clean and Maintain the Module


Clean and Maintain the Module

Before You Begin


1. Disconnect power before performing maintenance or cleaning.
2. To avoid personal injury or damage to the module, use only replacement parts and/or accessories obtained from BW Technologies or an authorized distributor.
3. No user-serviceable parts are inside the module.
4. If the module is damaged, Contact JJS Technical Services.

If the equipment is damaged or parts are missing, Contact JJS Technical Services.

Substitution of components may impair the safety of the equipment.

Do not attempt to disassemble, adjust, or service the equipment unless instructions are provided to perform a procedure, or a component is listed as a user-replaceable component in the user manual. Use only BW Technologies replacement components

Do not expose the equipment to electrical shock or severe and/or continuous mechanical shock.

Do not immerse the equipment in liquids.

Before You Begin

To maintain the module in good operating condition, perform the following basic maintenance as required:
1. Maintain a log of all maintenance that is performed.
2. Clean the exterior with a soft, damp cloth.

  • Do not immerse in liquids.
  • Do not use solvents, soaps or polishes.

3. Confirm that the inlet filter is free of dirt. Replace if required.

Once service is complete, reconnect the power supply. When power is connected, the LCD activates and self-test is performed.

Replacement Parts and Accessories

Replaceable parts are sold separately. To receive a complete list of replaceable parts approved for use with this product, Contact JJS Technical Services, or visit the product website at www.jjstech.com

Gas detectors, calibration and purge gas cylinders, and other accessories are sold separately. To receive a complete list of calibration gases and accessories approved for use with this product, Contact JJS Technical Services, or visit the product website at www.jjstech.com