1-866-4 JJSTECH(1-866-455-7832)

Reconfiguring the Detector (not applicable to the GasAlertClip Extreme)


Reconfiguring the Detector (not applicable to the GasAlertClip Extreme)

Fleet Manager II can reconfigure the following detectors with the base station:

  • GasAlert Extreme
  • GasAlertMicro
  • GasAlertMicro 5/PID/IR
  • GasAlertMicroClip
  • GasAlertMax XT

The detector can be reconfigured prior to performing a bump test or calibration.

To reconfigure a detector, complete the following:

  1. Activate the base station. Ensure it is in normal operation
  2. Ensure that a correctly formatted MMC/SD card is inserted in the base station. Refer to Inserting/Replacing a MMC/SD Card.
  3. Connect the USB cable to the computer and to the USB port on the base station.
  4. Activate the detector and wait until it is in normal operation
  5. Insert the detector into the detector bay.
  6. From the computer, open Fleet Manager II.
  7. Login to the Administration functions
  8. Under the Devices tab, click Configure Devices.
  9. The Load Configuration File dialog box displays.
  10. Select one of the following options:

    • Load existing configuration file from a MicroDock
    • Load existing configuration file from hard drive
    • Load default configuration file
  11. The Device Configuration dialog box displays.
  12. Select which device to configure by clicking its tab.
  13. Configure the device
    Ensure the Updatable checkbox is checked.
  14. Select a program option that will reprogram the detector. Each detector