1-866-4 JJSTECH(1-866-455-7832)

  1. Home
  2. Upgrading Microdock II Module Firmware

Upgrading Microdock II Module Firmware

Upgrading Modules

  • Firmware upgrade on slave docking module:
    • If docking module is attached to the Master (base) Module
      • Power system OFF and remove power cable from docking station
    • Remove "Warranty Void if Removed" label from bottom of docking module
    • Assemble PIC Programmer and adapter cable
      • Cable only fits one way
    • Insert appropriate MMC in PIC Programmer
    • Turn PIC Programmer ON by pressing Power (I) button on PIC programmer
      • Power LED will illuminate green
    • Insert other end of programming cable into connector on MicroDock II made accessible by removing "Warranty Void if Removed" label
    • Observe polarity
      • Pin 1 on cable - marked with arrow or triangle corresponds to pin 1 on MicroDock II - marked with dot on housing
    • NOTE:
      • Reversing cable polarity will cause fuse inside PIC Programmer to blow - rendering programmer unusable.
    • Press PROGRAM button on PIC Programmer
      • Program/Verify LED will blink red and green
      • When completed - LED will blink green only
      • Blinking red indicates programming failure
    • Only after green LED blinks - remove programming cable from MicroDock II module
    • Replace "Warranty Void if Removed" label
Module Firmware Revision
M5 GMCF-02A
GAMIC CSSF-20D
GAXT CSXF-01D
MC CSGF-10A
CLIPXT GMCF-01A