GasAlertMicroClip X3 Sensor Spares and Replacements

Part Number: MC2SS

MC2-SS-K1 Quad Sensor Screen Filters (kit of 10)

To extend the lifespan of your BW Technologies gas detection instrument, proper inspection and maintenance is required. When inspecting the device, be certain to regularly check the conditions of all filters. A clean filter will help to protect the device by preventing debris, dust, and moisture from entering the device, sensor, or pump. The Quad Sensor Screen Filters are compatible with certain BW Technologies devices (please check your device’s product specifications sheet for compatible) and is available in a pack of 10 screen filters.

Part Number: SRWMP75

SR-W-MP75C Replacement MICROpeL Combustible (LEL) Sensor

Keeping your gas monitor running smoothly and accurately is a vital task that ensures your safety. By routinely checking your sensors to verify that they are responding to gas is crucial. If you find that your LEL sensor is failing calibration or responding slowly you should immediately replace it. Combustible sensors are often contaminated by various substances in the environment and weaken over time. If this occurs please replace your sensor immediately.

Part Number: SR-X3P

SR-H-MC Replacement MICROceL Hydrogen Sulfide (H2S) Sensor

Make sure your monitor is protecting you by routinely changing your H2S sensor. Hydrogen Sulfide is one of the most potent dangers in today's working environment. Always bump check to make sure you are getting accurate readings. If your sensor is slow to respond or doesn't respond at all then replace immediately. Changing the sensor is a fast and easy process, simply open your monitor, slide out the existing sensor, and plug in the new one. Once it is installed you will need to re-calibrate your instrument before use.

SR-M-MC Replacement MICROceL Carbon Monoxide (CO) Sensor

• GasAlertMicroClip
• GasAlertMicroClip XT
• GasAlertMicroClip XL
• GasAlertMax XT
• GasAlertMax XT II

Part Number: SRWMCDUM

BW Technologies Dummy Sensor for 3-Pin O2 or 3-Pin Twin Tox Locations

The BW Technologies Dummy Sensor for 3-Pin O2 or 3-Pin Twin Tox Locations is a dummy sensor that acts as a placeholder for the device. This dummy sensor does not detect gases and does not initiate the alarm sequence on the device. The sensor can be used for training and storage purposes. This cost effective dummy sensor fits several BW Technologies products.

Part Number: SRDUMM1

Part Number: SRTOXMCDUM

Part Number: MCX3-FC1

Part Number: MCX3-FC1B

Part Number: MCX3-BC1

Part Number: MCX3-BC1B

Part Number: MCX3-MPCB1

Part Number: MCX3-FPCB1

Part Number: AA783-33HR