TPI 275 Clamp-On Tester with True RMS Digital Multimeter and 11,000 Count Display

275 Clamp-On Tester with True RMS Digital Multimeter and 11,000 Count Display by Test Products International

Clamp-On Tester with True RMS Digital Multimeter & 11,000 Count Display. The new TPI 275 with slim jaw and body is ideal for cramped work areas and crowded electrical panels.

The slim design 275 is a hand-held, autoranging clamp-on DMM. Extra large numerals, min/max, capacitance, DC microamps and duty cycle are just a few of the features of the 275. An affordable choice, the 275 offers measurements in all basic electrical functions with additional advanced features like non-contact voltage.

Features:

• True RMS
• 11,000 count display
• Up to 400 amps AC/DC
• Auto & Manual Ranging
• Data Hold
• Low Battery Indicator
• Over Range Indication ("OL")
• Peak Hold
• Min/Max
• Relative Mode
• Hi Voltage Indicator(>30V AC/DC)
• Non-contact voltage detection
• Auto Power Off after 30 minutes
• Separate Battery Compartment
• Low Ohm Range (110Ω)
• Amps AC Resolution: 0.01A
• VDC/VAC Resolution: 0.01mV
• DCiA measurement (0.01μA resolution)
• Temperature measurement

Applications:

• Measure DC amperage of motor drive units
• Measure flame safety control current
• Test run and start capacitors and motors
• Measure motor run current and capture peak motor start up amperage
• Measure heat anticipator current
• Determine thermocouple voltage
• Test line and control voltages
• Measure heating element resistance
• Measure air temperature in ducts
• Test for the presence of voltage in circuits without contacting the circuit
• Measure temperature differential using relative mode

The 275 comes complete with the following accessories:

• Carrying Pouch
• Test Lead Set
• Temperature Probe
• Instruction Manual
• Battery & Fuse