Work Plan: Assemble Individual Module

Follow these steps to assemble and prepare an individual module for first-time use:
1. Place the module and component parts on a clean, dry work surface.
2. Verify that the appropriate inlet key is inserted. Replace the inlet key if necessary. For more information, see Inlet Keys on page 9.
3. Assemble the stand, or mount the module on a wall or DIN rail. For more information see:

1. Assemble the Stand on page 16
2.Mount on a Wall on page 18.
3.Mount on Parallel DIN Rails on page 22.

4. Prepare the module for use.

1. Attach the end plate. For more information, see Attach the End Plate on page 26.
2. Connect an inlet filter to the purge inlet. For more information, see Connect the Inlet filter on page 28.
3. Insert an inlet plug into each unused inlet. For more information, see Insert the Inlet Plugs on page 29.
4. Connect the exhaust tubing. For more information, see Connect the Exhaust Tubing on page 27.
5. Connect the power. For more information, see Connect the Power on page 30.
6. Connect to a network. See Connect the Module to a Network on page 31.

5. Connect the calibration gas cylinder or cylinders, and then configure the gas inlets. For more information, seeConfigure Gas Inlets on page 41.